Delayed neutron yield measurement on thermal neutron induced fission of 237Np using cross-correlation technique
A technique of measuring the output of delayed neutrons of fission in the process of learning cores, with the help of a mechanical chopper. The use of neutron flux applied for demodulation, correlated with the modulation of the thermal neutron flux.
Подобные документы
Aimed at revealing of the draft mechanisms at the thermal power plants, which serve for continuous air supply to the boiler furnace. It is necessary for combustion process of fuel and removal of combustion products from the boiler into atmosphere.
статья, добавлен 25.11.2021The system of Dirac equations describing the dynamics of quarks in hadrons metric. Assumed that the quarks interact via an external Yang-Mills field. Magnetic moments of the proton, neutron and lambda baryon. Model of the baryons in a stationary metric.
статья, добавлен 29.04.2017The overall frame and principal steps of complex numerical modelling of thermal processes in power boiler furnaces on pulverised coal with tangential disposition of the burners. The methodology for creation of three-dimensional models of boiler furnaces.
статья, добавлен 02.02.2019Checking the accuracy of an experimental technique suggested earlier for determining piezooptic coefficients. It is based on inducing a predefined 2D distribution of mechanical stresses in a transparent material disk compressed along its diameter.
статья, добавлен 29.01.2016Study of heavy and superheavy nuclei. Small sectional synthesis SHN. Analysis of the height of the static fission barriers Bfst of heavy nuclei at the single particle. Determination of the energy of the odd nucleon. Static barrier spontaneous fission.
статья, добавлен 06.11.2013The efficiency of a thermal power cycle. Use of waste heat for process or central heating. Ways to increase the overall efficiency of the power plant. A combination of different thermodynamic cycles in a combined cycle. Once-through cooling systems.
статья, добавлен 20.02.2019Methodology and milestones defined density measurement of liquids, as well as the definition of its other parameters: isothermal compressibility, isobaric thermal expansion and pressure. Conformity assessment of the experimental density regulations.
статья, добавлен 08.04.2014Establishing the regularities of the thermal factor and radiation processing influence on the structure of ion-plasma coatings received by magnetron sputtering of quasi-binary WC-TiC system. Creation and use in practice ion-plasma multilayer coatings.
статья, добавлен 30.07.2016A consideration of process for impulse heat treatment of a silicon surface. The studying the thermal conductivity of a silicon powder and a polycrystalline wafer molded from powdered stock. Defining and comparing compounders with monocrystalline silicon.
статья, добавлен 29.07.2014Analysis of the measuring circuit to check the vibration of mechanical parts. Features of the development of a system that can timely identify a problem that could destroy the device. Familiarity with the reasons for the growing demand for equipment.
статья, добавлен 26.08.2020Study of formula for intrinsic stress calculation in coatings deposited from ion flux in the pulse potential mode. The case of deposition of ions with different charges. The critical parameters of pulse potential mode. Stress control deposited coating.
статья, добавлен 30.07.2016The review for different devices: Infrared sensor arrays for thermal imaging on active Si read-out chips, resonant cavity enhanced IR detectors, quantum well lasers on Si substrates and "wavelength transformers", structures operated in sub-threshold.
статья, добавлен 28.06.2013Photothermal effect of laser radiation on frozen biotissues. Тissue cryopreservation with using cooling, frizzing, laser heating. Тhe self-propagating high temperature synthesis. Using of nanoparticles high photo-thermal effect for laser of biotissues.
статья, добавлен 21.06.2018The measurement and analysis of the quality of electrical energy in electric grids. The characteristics of the main tools for measuring power quality, the requirements on the measurement of power quality. Instruments to measure the indicators of quality.
статья, добавлен 06.05.2018A five-phase inverter control algorithm in the over-modulation zone, which provides a transition from a linear modulation zone to a ten-step phase voltage. The results of the simulation of basic modes of operation in the zone of higher output frequencies.
статья, добавлен 02.02.2019Nonlinear regimes of 1D parametric instabilities of long-wave plasma waves are considered for the cases when the average plasma field energy density is less or greater than the plasma thermal energy. The evolution of ion energy distribution is studied.
статья, добавлен 27.07.2016Presents methods for evaluation and improvement of output quality of an autonomous power supply system. Characteristic of the output impedance of a switching voltage regulator. Research and analysis features of the process setup for measuring impedance.
статья, добавлен 24.05.2018Analysis of physical and numerical modeling of an electron emission and transport processes for different electron-optical energy conversion systems with nanostructured surface electron sources. Review of energy conversion processes with high efficiency.
статья, добавлен 30.07.2016Development of model for prestellar clouds. Thermal and chemical evolution. Effects of cosmic microwave background radiation. Role of metals in dust phases: a minimum model for metallicity effects. Reduced chemical model for low-metallicity clouds.
статья, добавлен 13.11.2013The problems of quantum gravity, the search for consistent schemes for the equations in quantum field theory. Perturbation theory and the Schwinger-DeWitt technique. A regular covariant method is for expanding the one-loop action in powers of curvatures.
книга, добавлен 09.09.2012Investigation of the differential capacity of a vibrating Coriolis gyroscope to suppress an external shock. Evaluation of the pulse amplitude in the voltage caused by external mechanical impact Analysis of the output signals of two measuring channels.
статья, добавлен 22.12.2016An efficient technique for analysis of waveguides, resonators and waveguide discontinuities in electromagnetic bandgap structures. Waveguides and resonators formed by elements removed from EBG array are considered. The first step is a solution of problem.
статья, добавлен 04.11.2018Summary of residual current devices. Its main purpose, operation and placement. Purpose of National Electrical Code. The process of RCDs. The process of replacing the two-wire (ungrounded) output. Photo of the internal mechanism of the residual current.
реферат, добавлен 08.11.2012The study forms the colliding nuclei. Defining the role of quadratic terms in the quadrupole deformations on the fusion cross section around the barrier induced deformed nuclei. The approach for determining the parameters of the nuclear potential.
статья, добавлен 19.09.2013The study of five-phase voltage inverters, regulated in accordance with the modified synchronous pulse width modulation algorithms.The multiplication of five-phase conversion systems with continuous and intermittent varieties of synchronous modulation.
статья, добавлен 02.02.2019