Thermodynamics of fragmentation of solids at severe plastic deformation
The study the fragmentation of solids during the process of severe plastic deformation using the Landau theory of phase transitions. Review of appearing defect structures of grain. Thermodynamics of fragmentation of solids at severe plastic deformation.
Подобные документы
Terahertz emitters - polaritonbased devices, where signals are generated from transitions between upper and lower polariton branches or bosonic cascade lasers. Band diagram of the double quantum wells system. Energy diagram of the dipolariton system.
статья, добавлен 30.07.2016Investigation of structural and spectral-luminescent properties of silica glasses and siliceous powders activated with CeO2:Ln3+. Analysis of the main features of the Ln3+ ions. Characteristic of relative intensity of magnetic dipole transitions of ions.
статья, добавлен 30.07.2016Induced transitions between a limit cycle and the state of the rest of the van der Pol has a threshold and disappears at rest. The threshold value is directly proportional to the product of the energy of oscillation and the coefficient of friction.
статья, добавлен 04.10.2014- 79. Twist extrusion
Research twist extrusion process and the development of its implementation. Characteristic features of the process of homogenization and mixing materials. Consideration of the stages of the formation of sub-micron and nanostructures in metals and alloys.
статья, добавлен 26.03.2016 In the visible range observed at high excitation levels originates from two-electron recombination transitions in the hole liquid. The critical temperature of the dipolar is substantially less than the spatially. The binding energy of free biexcitons.
статья, добавлен 30.07.2016Description of the concept of formation of micelles of surface-active substances. Features smooth polymorphic transitions, oscillations, and hysteresis properties in the size of the micelles. The use of active substances in the development of technology.
статья, добавлен 13.10.2016- 82. Solar energy
The essence of the process of using solar energy in the areas of alternative energy. The process of generating electricity using solar cells. The advantages and disadvantages of the introduction of solar energy. The use of photovoltaic installations.
презентация, добавлен 23.12.2013 Summary of residual current devices. Its main purpose, operation and placement. Purpose of National Electrical Code. The process of RCDs. The process of replacing the two-wire (ungrounded) output. Photo of the internal mechanism of the residual current.
реферат, добавлен 08.11.2012Analysis of thermal stability, features of structure, physical-mechanical descriptions of thin wearproof coverages on the basis of diborides of transitional metals, under act of high temperatures. Studding the optimization model of cutting process.
статья, добавлен 30.07.2016The anisotropic mechanical response of metals to large strains at low homologous temperatures. Initial grain orientations and the corresponding slip rates as predicted by a full constraints Taylor code. Substructure and texture evolution of metals.
статья, добавлен 28.10.2018The analytical expression for the calculation of the relay mode frequency and power. Development of parameters of electric energy converters. The absence of the phase shift between voltage and current. Solution EMC problems. The reduction of power losses.
статья, добавлен 29.07.2016Results changes in the structure of materials at pulsed plasma processing on the accelerator. Changes in physico-mechanical properties because the structure and phase transformations in a material when the difference of parameters of the plasma exposure.
статья, добавлен 13.10.2016Carrying out of complex research of a new type of the tubular mechanism on the basis of differential friction of bristles. Development and experimental testing of a new type of mechanism based on SMA. Problems with the cooling phase due to prolonged use.
статья, добавлен 29.08.2020Сети с изолированной нейтралью и устройства формирования линейных, квадратичных интегральных критериев. Фиксация значений критериев, при изменениях напряжения контролируемой сети. Окно задачи параметров блока Three-phase Programmable Voltage Source.
статья, добавлен 17.06.2018Preparation and characterization of single phase nanoparticles with a copper complex as precursor via microwave technique. Identification and analysis of scanning electron microscopy, ultraviolet-visible spectroscopy and photoluminescence spectroscopy.
статья, добавлен 30.07.2016Familiarity with the main features of the experimental study of hydrodynamic luminescence in a cavitating liquid medium, problem analysis. General characteristics of important stages of development of the basic hydraulic scheme of the test bench.
статья, добавлен 20.09.2021The history of the effects of the first induction motor. Record status induction improvements and the development of three-phase asynchronous motors. The use of electric motors in modern technology. Features of the nature of induction machines.
реферат, добавлен 03.04.2014Optimal conditions for the synthesis of nanopowders based bi2te3. Preparation of homogeneous dense material from nanopowder by hot isostatic pressing. Especially the increase in electrical resistivity, decrease in the average grain size of the material.
статья, добавлен 13.10.2016Thermal treatment results in the formation of additional amorphous nanoclusters and in their crystallization with anneal temperature increasing. Nitride films annealed at 1200 °C contain crystalline Si clusters only. Characteristics of SiNx films.
статья, добавлен 30.07.2016Asymptotic formulas for stray fields of arbitrarily oriented magnetic and electric dipoles located on the axis of a translucent disk. Using the Kirchhoff approximation and the stationary phase method. Numerical solution of a singular integral equation.
статья, добавлен 05.11.2018The benefits of using improved magnetic materials for electric devices. The mechanism of effect of magnetic field on the formation of ferrite particles in the polymer matrix composites. The calculation of the amount of filler in a phase transition.
статья, добавлен 30.07.2016A mathematical model of multiphase cylindrical apparatus for bulk materials treatment with radio frequency electric field. Analysis of the distribution of the electric field inside the zone restricted with multiple connected circular arc-shaped boundary.
статья, добавлен 29.07.2016The procedure of coordinating solutions for individual subsystems and does not require iterative calculations by subsystem. Setting the nodes with PMU as slack nodes of subsystems provides coordination of voltage phase angles in subsystem calculations.
статья, добавлен 23.06.2013- 99. The viscosity temperature dependence in the boundary friction model under a periodic external action
Investigation the tribological system behavior with help of the thermodynamic model, which takes into consideration the dependence of the effective polymeric lubricant viscosity on the temperature and velocity gradient within phase transition model.
статья, добавлен 30.07.2016 Presented PDE-method for solution of the Fokker-Planck Equation is proposed to study the beam dynamic in the storage ring. This method has been implemented in the new OPLEQ code. The results of numerical calculations obtained by this code are presented.
статья, добавлен 12.09.2013