On lorentz invariance of random processes
Self-similarity of random processes as a condition of Lorentz invariance. It is shown that this condition corresponds to white and pink noise, as well as the Brownian process, supplemented by any random process with the property of self-similarity.
Подобные документы
Distribution of solid solution on phase diagram. Solid homogeneous feldspars. Term for albite exsolution lamellae in K-spar matrix. Examples of post-crystallization. Smoother boundaries from recrystallization. Replacement of one mineral by another.
презентация, добавлен 23.02.2012The paper describes a gas phase process for the preparation of cotton fabrics coated with silver nanoparticles as antimicrobial agents. Application to cotton fabrics. Synthesis of silver nanoparticles. The bactericidal activity of the cotton fabrics.
статья, добавлен 30.07.2016The neutron time of flight (n_TOF) facility at CERN. Measurement of neutron capture cross sections in the S-process nucleosynthesis. Galactic condensation and the formation of stars. Checking models of stellar evolution. Mechanisms of neutron capture.
статья, добавлен 24.09.2013A new hydrodynamic theory. The structure formation in deformed materials. Self-consistent non-local formulation of the boundary-value problem for a high-strain-rate process. A penetration for a flat rigid plate into a viscous elastic medium.
статья, добавлен 28.10.2018Solar and water power. Nuclear power plants. Appropriate regions for alternative energy. Environmental problems that may have a terrible influence on the future of the world. Greenhouse effect is the emissions of different gases in the process of firing.
презентация, добавлен 21.06.2015A method of a research of irregular multimode optical waveguides as nonlinear dynamic dissipative systems. The scattering of a controlled mode as a process of transition of a certain dynamic dissipative system from an "ordered" state to a "chaos" state.
статья, добавлен 07.11.2018A technique of measuring the output of delayed neutrons of fission in the process of learning cores, with the help of a mechanical chopper. The use of neutron flux applied for demodulation, correlated with the modulation of the thermal neutron flux.
статья, добавлен 19.09.2013The efficiency of a thermal power cycle. Use of waste heat for process or central heating. Ways to increase the overall efficiency of the power plant. A combination of different thermodynamic cycles in a combined cycle. Once-through cooling systems.
статья, добавлен 20.02.2019Presents methods for evaluation and improvement of output quality of an autonomous power supply system. Characteristic of the output impedance of a switching voltage regulator. Research and analysis features of the process setup for measuring impedance.
статья, добавлен 24.05.2018Development of a method for increasing the energy efficiency of a household refrigerator by intensifying the process of heat removal from the refrigeration unit with modern fans for blowing the surfaces of the compressor and condenser unit of the device.
статья, добавлен 20.06.2020The effects of increase in photoconductivity in the macroporous silicon structures. Founding to achieve a maximum at the distance between macropores equal to the double thickness of the Shottky layer what corresponds to the experimental results.
статья, добавлен 01.04.2014Concept of energy security. Direction of Poland's energy transformation, diagnosis of threats and challenges. Production and forecast of electricity production in country up to 2040. Reduction of emissions, nuclear power plant, renewable energy sources.
статья, добавлен 26.09.2022Influence of oil impurities on the characteristics of isobutane boiling process in the evaporator complex setup. Dependence of oil concentration before throttling versus mass flow rate, of the local heat transfer coefficient from concentration of oil.
статья, добавлен 30.01.2016Replacement scheme for the calculation of short-circuit time search space for the simplest plot. Diagram of distribution line. Example of calculation for one moving line of AXO between section lines. Scheme of control process of finding places SC line.
статья, добавлен 23.05.2016Description of the experimental stand of a multi-motor hydraulic drive providing synchronous movement of motors. An automated control system for the movement of elements of a multi-motor hydraulic drive. Creation of a model for calculating motion errors.
статья, добавлен 22.02.2021Aimed at revealing of the draft mechanisms at the thermal power plants, which serve for continuous air supply to the boiler furnace. It is necessary for combustion process of fuel and removal of combustion products from the boiler into atmosphere.
статья, добавлен 25.11.2021A consideration of process for impulse heat treatment of a silicon surface. The studying the thermal conductivity of a silicon powder and a polycrystalline wafer molded from powdered stock. Defining and comparing compounders with monocrystalline silicon.
статья, добавлен 29.07.2014Analysis of data on ultrasonic absorption in magnetic nanofluids. The explanation of the peaks of the absorption coefficient of ultrasound using the process of relaxation of the magnetic field to its equilibrium value in the model of magnetic fluid.
статья, добавлен 05.11.2018Photothermal effect of laser radiation on frozen biotissues. Тissue cryopreservation with using cooling, frizzing, laser heating. Тhe self-propagating high temperature synthesis. Using of nanoparticles high photo-thermal effect for laser of biotissues.
статья, добавлен 21.06.2018Water mills are considered as landscape-technical systems, which became the root cause of the transformation of modern valley-river landscapes of the Right Bank of Ukraine. The process of reconstruction of water mills at a hydroelectric power plant.
статья, добавлен 24.11.2020Analysis of the electric circuit of a hybrid electric machine that functions as a starter and generator. Design, material savings, optimization of the starter mode, generator, starting relay, battery, rectifier units. The process of starting the machine.
статья, добавлен 14.12.2024Characteristic features of the effect of noise on the power and polarization characteristics of semiconductor lasers within the scope of our earlier model which considers polarization switching. Research and analysis of results of numerical simulation.
статья, добавлен 29.01.2016The study the fragmentation of solids during the process of severe plastic deformation using the Landau theory of phase transitions. Review of appearing defect structures of grain. Thermodynamics of fragmentation of solids at severe plastic deformation.
статья, добавлен 30.07.2016The deterministic spherical motion of the ferromagnetic fine particle with frozen magnetic moment is considered. Using the equations of motion and the mode of torsional oscillation. The influence of the static field on the magnitude of the power loss.
статья, добавлен 30.07.2016Induced transitions between a limit cycle and the state of the rest of the van der Pol has a threshold and disappears at rest. The threshold value is directly proportional to the product of the energy of oscillation and the coefficient of friction.
статья, добавлен 04.10.2014