Influence of the thermal factor on the structural and substructural states of the quasi-binary tic-wc system ion-plasma coatings
Analysis of the deposition temperature of TiC-WC quasi-binary system ion-plasma coatings (magnetron scheme) of different composition. Extension of structural, substructural States in terms of non-equilibrium producing a material of the ion-plasma flows.
Подобные документы
Characteristic features of lasers operating in continuous-wave or quasi-CW regimes generate a restricted output optical power, which is limited by a maximum available pump power. Analysis Raman spectrum measured for the graphene-deposited fibre ferrule.
статья, добавлен 29.01.2016Quantification of plastic strain by crystal orientation. Crystal orientation distribution and calculation of crystal deformation. Influence of the EBSD system. Relation with plastic strain. Misorientations from central orientation in each grain.
статья, добавлен 18.01.2014Investigation of reverse effects in non-residential buildings after thermal modernization. Study of actual and calculated indicators of heat consumption before and after thermal modernization. Development of a technique for determining reverse effects.
статья, добавлен 01.12.2017Thermal treatment results in the formation of additional amorphous nanoclusters and in their crystallization with anneal temperature increasing. Nitride films annealed at 1200 °C contain crystalline Si clusters only. Characteristics of SiNx films.
статья, добавлен 30.07.2016Terms of eikonal distribution expansion in the aperture of a symmetric two-mirror visualization system in powers of a source transverse displacement from one of the foci. Definition terms of the expansion through the mapping function and its derivative.
автореферат, добавлен 05.11.2018Two variants of the operative conditions of heat and power plants with technological schemes where heat pumps are used for utilizing the heat of exhaust gases of steam generators. System of the automatic control of frequency and power as power system.
статья, добавлен 30.01.2016Design of multi-input devices of relay protection and automatics on the basis of the structural linguistic method. The development of the steady-state devices in the conditions of variety of input meaningful situations. Methods of improvement of CAD.
статья, добавлен 09.09.2016The introduction of sulfur in the liquid condensates of zinc oxide as one of the ways to create efficient phosphors based on this material. Application of the method of extrapolation of Nelson-Riley to obtain accurate values of the lattice constant.
статья, добавлен 30.07.2016The operation of the photoconversion system based on dual voltage inverters with synchronous intermittent modulation algorithms. Analysis of systems with two basic types of synchronous intermittent modulation and under different operating conditions.
статья, добавлен 02.02.2019The main aim development of the Uniform power system of Russia consists in maintenance of a reliable and economic electrical supply of consumers in territory with the greatest possible realisation of advantages of parallel work of power supply systems.
статья, добавлен 30.04.2019- 61. Influence of low-frequency electromagnetic radiation on the complement system (experimental study)
Determination of the state of the complement system under conditions of exposure to low-frequency electromagnetic radiation on the body of rats under experimental conditions. Replace in membrane potential and disruption of nerve cell conduction.
статья, добавлен 12.05.2024 Alignment of the wafer surface, allowing to achieve a high degree of homogeneity of the electrophysical characteristics of semiconductors. Efficiency of using nanometer-sized abrasive particles and a modified composition of the polishing suspension.
статья, добавлен 09.12.2024Presents methods for evaluation and improvement of output quality of an autonomous power supply system. Characteristic of the output impedance of a switching voltage regulator. Research and analysis features of the process setup for measuring impedance.
статья, добавлен 24.05.2018Calculation of reliability as an object’s complex. The procedure of setting the appropriate indicators using methods based on their definition by reference data about the object elements’ and the analog objects’ reliability, data on material properties.
статья, добавлен 29.11.2016Analysis of thermal stability, features of structure, physical-mechanical descriptions of thin wearproof coverages on the basis of diborides of transitional metals, under act of high temperatures. Studding the optimization model of cutting process.
статья, добавлен 30.07.2016The structure of the intelligent diagnostic system for power transformer equipment. The use of zeolite as a "drier" in the molecular sieve. Parameters of the moisture management system. Dehumidification of the insulation of oil-filled transformers.
статья, добавлен 10.12.2024The theoretical analysis of the temperature dependences in linear voltammetry in this communacation for reversible and totally irreversible electrochemical processes. Features of studing means of linear voltammetry technique in sulfare solutions.
статья, добавлен 27.07.2016Analysis of the results of irradiation of thin films of zinc selenide 500 nm thick by an electron beam and their deposition by evaporation. Analysis of the optical properties of both irradiated and untouched samples using an ultraviolet spectrophotometer.
статья, добавлен 23.12.2016The essence of the method of a round flat constant power probe used to determine the thermal characteristics of solids. Formulas for calculating thermal conductivity and thermal diffusivity. Measuring equipment, analysis of experimental results.
статья, добавлен 30.05.2021- 70. Creaking Door
Defining the parameters of the slip at a constant level kinetic friction. Provides an analytical scheme for solving the problem for a system with uncertain coordinates. The amplitude of oscillation of the changes and built a sine wave of the function.
лекция, добавлен 26.05.2014 Simulation of cold rolling of bearing rings taking into account the temperature factor. Optimization of the shape of the roller generatrix of double-row railway roller bearing. The hydraulic resistance of mesh dividers of phases in the liquid stream.
статья, добавлен 29.06.2016Socioeconomic development and increase in population demand for electric power. Problems of compensation of reactive power of the power system. Management of the electric grid mode to match voltage indicators with the standards of the power supply mode.
статья, добавлен 07.12.2024Peculiarities of research into the problem of reliability of automotive power supply systems. The main characteristic of the power supply system testing methodology. Consideration of the main classification of failures of automotive electrical equipment.
статья, добавлен 08.12.2024The temperature effect on the phase composition, on variation in diffuse reflection spectra. Absorption coefficient of titanium dioxide powder during heating and modification by silicon dioxide nanoparticles. The irradiation with accelerated electrons.
статья, добавлен 12.09.2016Concept and the magnetic ballast control system for High Intensity Discharge lamp using the technology of the ZigBee wireless network is introduced. Investigation of the electronic switch unit driven by ZigBee system of lighting network is presented.
статья, добавлен 12.07.2013