Switching discharge phenomena when use composite materials Cu—Cr under low voltage dc inductive load of a small power

Use of composite materials Cu-Cr in electric contacts operating under DC low voltage loads of a small power. Сonclusions of possibility of the use of such material to control the arc to glow transformation for use in electric auxiliary switching devices.

Подобные документы

  • A five-phase inverter control algorithm in the over-modulation zone, which provides a transition from a linear modulation zone to a ten-step phase voltage. The results of the simulation of basic modes of operation in the zone of higher output frequencies.

    статья, добавлен 02.02.2019

  • Split-phase symmetrical motor drive on the base of two voltage source inverters, controlled by algorithms of synchronized pulse width modulation, has been investigated. Simulation results are presented for dual three-phase power conversion systems.

    статья, добавлен 02.02.2019

  • Review and description high reliability and security of power unit are basic requirements when the power unit maneuvering mode operation. Investigated of the power unit capacity automated control systems influence on axial offset under maneuvering mode.

    статья, добавлен 29.11.2016

  • The descriptive structure and implementation of motor driver for solar power plant is proposed. Determination and characterization of the direct loss of power, depending on the angle of deviation. The development of solar power control algorithm.

    статья, добавлен 26.06.2016

  • Issues of scientific justification of electromagnetic compatibility assurance links, reliability theory and resources in the creation and operation of electrical complexes in electric power networks and systems. The increase in resource of electrical.

    статья, добавлен 28.01.2020

  • Two variants of the operative conditions of heat and power plants with technological schemes where heat pumps are used for utilizing the heat of exhaust gases of steam generators. System of the automatic control of frequency and power as power system.

    статья, добавлен 30.01.2016

  • The fabrication of a molecular transistor based on a single molecule trapped in a few-layer graphene nanogap. The three-terminal transistors. Feedback-controlled electroburning. The current-voltage characteristic. The measure electron transport.

    статья, добавлен 30.07.2016

  • Discusses the issue of introducing renewable electricity generation sources in Ukraine's integrated power system after imposing feed-in tariff. Identification and analysis negative repercussions on reliable supply of electric power to local consumers.

    статья, добавлен 28.02.2016

  • Analysis of perspectives of development of renewable energy sources in Poland in the future. Investigation and characterization of the cumulative power installation and electric energy production. Definition of the forecast of power installation.

    статья, добавлен 22.03.2016

  • The implementation of the algorithm of the mathematical model, the procedure for calculating the necessary expressions and their type of representation. Programming sequence of the mathematical model consideration. The equations for current and voltage.

    статья, добавлен 02.02.2019

  • Introduction to the history of creation Kazakhstan Electricity Grid Operating Company. The definition and characterization basic objectives of this company - provide performance reliability of the unified power system of the Republic of Kazakhstan.

    презентация, добавлен 07.03.2015

  • The energy industry is energy, which includes generation, transmission and distribution of electricity. Thermal power plant is a power plant producing electrical energy by converting chemical energy. Nuclear power plant is a complex of necessary systems.

    статья, добавлен 19.02.2019

  • The concept and characteristics of the electric current. Analysis of linear DC circuits. Applying Kirchhoff's in electrical engineering. The nodal equations for complex amplitudes. Representation of harmonic oscillations with the help of complex numbers.

    методичка, добавлен 11.10.2014

  • Deposition of CuPc under the electric field and without it. The influence of the field on morphological properties. Quantum-chemical modeling and growth mechanisms. The electrical characteristics of the amorphous and crystalline structure of the films.

    статья, добавлен 30.07.2016

  • Electric current and its effect on the body. The types of effects that current levels can have on the body. The effect of current on the electric shock. An explanation of some of the most common effects of an electric shock. Consequences of shock.

    статья, добавлен 20.02.2019

  • A transit time of light through the system. The magnetic field oscillations. The studying a Faraday’s law. The resistance of an electric wires and contacts. Levitation of conductors in an oscillating field. Methods for choosing the discrete differences.

    лабораторная работа, добавлен 26.05.2014

  • Importance of the different parameters of wearing out of power transformer insulation prediction structure and operating factors. Selection of configuration and parameters of paper insulation and transformer oil technical state models is investigated.

    статья, добавлен 29.07.2016

  • Incompressible fractional flow for waterflood with capillary corrections. Mass balance closure for the composite solution. Composite saturation profile and fractional flow plot for radial flow. Model application - capillary pressure function calibration.

    статья, добавлен 21.09.2016

  • Development of rotor mechanisms, which make it possible to use solar radiation as efficiently as possible. The design and structure of a solar power plant. Scheme of control and balancing of output power. Selection of the type of photovoltaic cells.

    статья, добавлен 22.12.2016

  • The numerical-analytic approach to solve the stress-strain state problems of an arbitrary finite element simple-connected composite object with different surface mounting types. The main problem is solvedby using the elasticity theory spatial model.

    контрольная работа, добавлен 27.01.2014

  • Types of wind power stations: ground, coastal, offshore, floating. The principle of operation of wind parks, transportation of resulting electricity through a power cabinet located on the basis of a wind power plant. Terms of construction of wind farms.

    презентация, добавлен 16.05.2018

  • Research of the radiation absorption of nanocomposites consisting of polymer matrix and metal particles filler obtained in result of electric explosion. Advantages of the method of composite polymer system creation for resistant to external actions.

    статья, добавлен 23.12.2016

  • The efficiency of a thermal power cycle. Use of waste heat for process or central heating. Ways to increase the overall efficiency of the power plant. A combination of different thermodynamic cycles in a combined cycle. Once-through cooling systems.

    статья, добавлен 20.02.2019

  • Areas of application electrodispersion meniscus and the capillary breakup of jets of liquids in a variety of industries with current technology. Education of pulsating microcones. The dynamics of the water meniscus depending on the applied voltage.

    статья, добавлен 13.10.2016

  • Principles of construction of a monitoring system. Appearance of the reflectometer ALIMP. Application of the complex modulated signals. Algorithms of processing of the information. Block scheme of power lines monitoring on the basis of the devices ALIMP.

    статья, добавлен 08.05.2013

Работы в архивах красиво оформлены согласно требованиям ВУЗов и содержат рисунки, диаграммы, формулы и т.д.
PPT, PPTX и PDF-файлы представлены только в архивах.
Рекомендуем скачать работу и оценить ее, кликнув по соответствующей звездочке.